| No. | Poster Title | Name (Place at NIMS) | Place (Outside NIMS) |
|---|---|---|---|
| P1-01 | Nanophase-separated alloys as precious-metal-free exhaust catalysts |
Tsubasa Imai
Center for Green Research on Energy and Environmental Materials
|
Saitama University |
| P1-02 | Active voltage contrast imaging of multilayer ceramic capacitor using helium ion microscopy |
Chikako Sakai
Global Research Center for Environment and Energy Based on Nanomaterials Science (GREEN)
|
|
| P1-03 | Side products on the cathode in nonaqueous lithium-oxygen secondary batteries: water induced decomposition of dimethyl sulfoxide |
Kentaro Tomita
Global Research Center for Environment and Energy Based on Nanomaterials Science (GREEN)
|
|
| P1-04 | Hydrogen separation from ammonia decomposed gas by vanadium alloy membrane |
Jeng-Ting Tsai
Center for Green Research on Energy and Environmental Materials
|
Taipei University of Technology |
| P1-05 | Carrier dynamics at the interface between MAPbI3 perovskite and carrier transport layers |
Bobby Barker
Global Research Center for Environment and Energy Based on Nanomaterials Science (GREEN)
|
University of South Carolina |
| P1-06 | Sputter deposited metal oxide thin films as hole transport material for efficient perovskite solar cells |
M. Bodiul Islam
Global Research Center for Environment and Energy Based on Nanomaterials Science (GREEN)
|
University of Yamanashi |
| P1-07 | Highly enhanced electrocatalytic evolution of hydrogen at insulating boron nitride modified gold |
Ganesan Elumalai
Global Research Center for Environment and Energy Based on Nanomaterials Science (GREEN)
|
|
| P1-08 | Enhancement in efficiency and optoelectronic quality of perovskite PV materials following MACl ambient annealing |
Dhruba B. Khadka
Global Research Center for Environment and Energy Based on Nanomaterials Science (GREEN)
|
|
| P1-09 | Ni-Fe-Mg alloy nanoparticle catalysts for hydrogen production |
Haruka Mitani
Center for Green Research on Energy and Environmental Materials
|
Tokyo University of Science |
| P1-10 | Preparation and characterization of transparent garnet-type Al-doped Li7La3Zr2O12 for lithium battery applications |
Shoichi Sugata
NIMS Open Innovation Center
|
|
| P1-11 | Substitution effect on the thermoelectric properties in K8Ga8Si38 |
Shiva Kumar Singh
Research Center for Functional Materials
|
|
| P1-12 | Surface chemical state of (La,Sr)CoO3 for cathode of solid oxide fuel cells |
Shogo Miyoshi
Center for Green Research on Energy and Environmental Materials
|
|
| P1-13 | Role of carrier transport in hole transport layer on photovoltaic properties of perovskite solar cells |
Masatoshi Yanagida
Global Research Center for Environment and Energy Based on Nanomaterials Science (GREEN)
|
|
| P1-14 | High stability of low-temperature processed perovskite solar cells with sputtered inorganic layers |
Yasuhiro Shirai
Global Research Center for Environment and Energy Based on Nanomaterials Science (GREEN)
|
|
| P1-15 | TiN coated ceramic fiber wool for photothermal water heating and vaporization |
Kaur Manpreet
International Center for Materials Nanoarchitectonics (MANA)
|
Hokkaido University |
| P1-16 | Independent influence of cell adhesion and spreading on differentiation of human mesenchymal stem cells |
Xinlong Wang
International Center for Materials Nanoarchitectonics (MANA)
|
University of Tsukuba |
| P1-17 | A mild polymerization approach for single mammalian cell encapsulation |
Jianmin Yang
International Center for Materials Nanoarchitectonics (MANA)
|
|
| P1-18 | Potential-dependent double resonance sum frequency generation spectroscopy to probe electronic state at solid/liquid Interface |
Shuo Yang
International Center for Materials Nanoarchitectonics (MANA)
|
|
| P1-19 | High efficiency silicon hybrid solar cells via energy management by employing nanocrystalline Si quantum dots and Si nanoholes |
Thiyagu Subramani
International Center for Materials Nanoarchitectonics (MANA)
|
|
| P1-20 | Metallic nickel-iron bi-metal pyrite eletrocatalyst for oxygen evolution reactions |
Min Zhou
International Center for Materials Nanoarchitectonics (MANA)
|
Yangzhou University |
| P1-21 | Novel diamond anvil cell for electrical measurements using boron-doped metallic diamond electrodes |
Ryo Matsumoto
International Center for Materials Nanoarchitectonics (MANA)
|
University of Tsukuba |
| P1-22 | Direct observation of phase separation between superconductor and insulator on the single crystals of KxFe2-ySe2 |
Masashi Tanaka
International Center for Materials Nanoarchitectonics (MANA)
|
|
| P1-23 | Amorphous P@graphene paper for ultrastable sodium-ion batteries |
Chao Zhang
International Center for Materials Nanoarchitectonics (MANA)
|
University of Tsukuba |
| P1-24 | Tuning band gaps of h-BN through chemical functionalization |
Qunhong Weng
International Center for Materials Nanoarchitectonics (MANA)
|
|
| P1-25 | Synthesis of mercury-based high-Tc superconductors using CsCl catalyst |
Hiroshi Hara
International Center for Materials Nanoarchitectonics (MANA)
|
University of Tsukuba |
| P1-26 | p-Zinc oxide/n-silicon nanowire heterojunctions for optoelectronics |
Ken Pradel
International Center for Materials Nanoarchitectonics (MANA)
|
|
| P1-27 | Exploring magnetic-field-tolerant superconductivity in atomic-layer materials |
Shunsuke Yoshizawa
International Center for Materials Nanoarchitectonics (MANA)
|
|
| P1-28 | Synthesis and performance improvement of iron chalcogenide superconductors by electrochemical technique |
Aichi Yamashita
International Center for Materials Nanoarchitectonics (MANA)
|
University of Tsukuba |
| P1-29 | Enhancement of superconductivity in EuFBiS2 using high pressure |
Kouji Suzuki
International Center for Materials Nanoarchitectonics (MANA)
|
University of Tsukuba |
| P1-30 | Low doses of TiO2-PEG nanoparticles stimulate proliferation of hepatocyte cells |
Qingqing Sun
Research Center for Functional Materials
|
Waseda University |
| P1-31 | Investigation of new bronze alloys for high performance Nb3Sn superconducting wires |
Hiroyasu Taniguchi
Research Center for Functional Materials
|
Osaka Alloying Works, Co., Ltd. |
| P1-32 | Development of fluoride ion removal materials using sea urchin shells as a marine waste |
Yuka Takemura
Research Center for Functional Materials
|
Hokkaido University |
| P1-33 | Wearable toxic gas sensor based on supramolecular carbon nanotube wrapper and near field communication technology |
Shinsuke Ishihara
International Center for Materials Nanoarchitectonics (MANA)
|
Massachusetts Institute of Technology |
| P1-34 | Operando analysis of all-solid-state Lithium ion batteries using nanoscale electrical potential measurement and Li mapping |
Hideki Masuda
Research Center for Advanced Measurement and Characterization
|
|
| P1-35 | Advanced in situ multi-scale characterization of mechanical properties of carbon-fiber-reinforced plastic |
Hongxin Wang
Research Center for Advanced Measurement and Characterization
|
|
| P1-36 | Giant magnetic refrigerant materials for hydrogen liquefaction |
Saori Toyoizumi
Research Center for Advanced Measurement and Characterization
|
Tokyo Denki University |
| P1-37 | Analysis of micrometer-sized precipitates in Heat-Resistant Steels by TOF-SIMS |
Norimichi Watanabe
Research Center for Advanced Measurement and Characterization
|
|
| P1-38 | Direct observation of dye molecules for solar cell on a titania nanosheet surface by ADF-STEM |
Shogo Koshiya
Research Center for Advanced Measurement and Characterization
|
|
| P1-39 | Quantum size effects in the nonlinear response of metal plasmonic nanoparticles |
Rodrigo Sato
Research Center for Advanced Measurement and Characterization
|
|
| P1-40 | Influence of Ti on mechanical properties and structure of Ni-free ODS steel |
Agata Kowalska
Research Center for Advanced Measurement and Characterization
|
Warsaw University of Technology |
| P1-41 | Nanoparticle-decorated graphene for advanced battery design |
Phillip David Bentley
Research Center for Advanced Measurement and Characterization
|
University of York |
| P1-42 | Perpendicular magnetic anisotropy in Co/Ni multilayers studied with high brightness and highly spin-polarized LEEM |
Masahiko Suzuki
Research Center for Advanced Measurement and Characterization
|
|
| P1-43 | Manipulation of ferroelectric and magnetic domains in a multiferroic Bi0.9La0.1FeO3 thin film |
Tingting Jia
Research Center for Functional Materials
|
|
| P1-44 | Modeling of dynamic behavior of interfacial bonding using EFIT and its experimental validation |
Asriana Ibrahim |
Ehime University |
| P1-45 | Two dimensional mapping system for permeated hydrogen on stainless steel |
Satsuki Nakamura |
Toho University |
| P1-46 | Plasmon-enhanced fluorescence from Ag nanoparticle-doped pyrolytic DNA nanofibers |
Hidenobu Nakao
Research Center for Advanced Measurement and Characterization
|
|
| P1-47 | NMR spectroscopy under photo-illumination at low temperatures |
Atsushi Goto
Research Center for Advanced Measurement and Characterization
|
|
| P1-48 | The iron making from Fe2O3 by use of ceramics with in situ TEM |
Nobuhiro Ishikawa
Research Center for Advanced Measurement and Characterization
|
|
| P1-49 | Sustainable construction materials: characteristics of stabilized soil |
Santosh Shrestha
Research Center for Structural Materials
|
|
| P1-50 | Effect of Phase Stability on Low-Cycle Fatigue Properties in Fe-28Mn-6Si-5Cr Shape Memory Alloy |
Wataru Tasaki
Research Center for Structural Materials
|
University of Tsukuba |
| P1-51 | Nature-adapted next-generation coatings and adhesives |
Debabrata Payra
Research Center for Structural Materials
|
|
| P1-52 | Investigation of the influence of elemental distribution in Ti-12Mo alloy on its mechanical properties by nanoindentation test |
Jovana Ruzic
Research Center for Structural Materials
|
|
| P1-53 | First-principles study of the phase stability and elastic properties of Ti-X alloys (X = Mo, Nb, Al, Sn, Zr, Fe, Co, and O) |
Wenchong Zhou
Research Center for Structural Materials
|
University of Tsukuba |
| P1-54 | Creep properties of near-α titanium alloys consisting of an acicular microstructure |
Tsutomu Ito
Research Center for Structural Materials
|
National Institute of Technology, Kagawa College |
| P1-55 | Hydrogen entry into high strength steel in wear-corrosion environment including Cl- |
Kotaro Doi
International Center for Young Scientists (ICYS)
|
|
| P1-56 | Design and development of heat-resistant high-strength Ti alloys for jet engines |
Tomonori Kitashima
Research Center for Structural Materials
|
|
| P1-57 | DAMAS: an annotation support tool for material information |
Thaer M. Dieb
Center for Materials research by Information Integration
|
|
| P1-58 | Application of DFT and informatics for screening ion conductive ceramics |
Randy Jalem
Global Research Center for Environment and Energy Based on Nanomaterials Science (GREEN)
|
|
| P1-59 | Search for magnet materials based on materials informatics |
Tomoki Yamashita
Center for Materials research by Information Integration
|
Osaka University |
| P1-60 | First principles calculations and machine learning of magnetic properties |
Hitoshi Fujii
Center for Materials research by Information Integration
|
Osaka University |
| P1-61 | Preliminary experiments: causal relation extraction from natural language texts for material development |
Takeshi Ohnishi |
Toyota Technological Institute at Chicago |
| P1-62 | Improvement of moisture resistance of La2O3 by impurity doping |
Yutaka Adachi
Research Center for Functional Materials
|
|
| P1-63 | Research and development of Nb3Al superconducting wires for high magnetic field applications |
Yasuo Iijima
Research Center for Functional Materials
|
|
| P1-64 | TEM characterization of a Mg2Si0.5Sn0.5 solid solution for high-performance thermoelectrics |
Minghui Song
Transmission Electron Microscopy Station
|
|
| P1-65 | Development of Nb3Sn wire using Cu-Sn-Zn ternary bronze matrix for the prototyped fusion reactor "DEMO" application |
Yoshimitsu Hishinuma
Research Center for Functional Materials
|
National Institute for Fusion Science |